XC90SectionGroupWeight(Kg/Pounds)YearMonth33661 (2.1)200705XC90 2003, XC90 2004, XC90 2005, XC90 2006, XC90 2007, XC90 2008, XC90 2008, XC90 2009, XC9
21IMG-242227 Installing the camera●Insert the cable through the rubber grommet. The end of the grommet that has a lip should sit in the body and the p
25IMG-242232 Installing the camera● Press the cable clip in the hole. If the hole is being used, secure it by the existing cable with a cable tie.26IM
29IMG-242236 Installing the camera● Place the template over the hole for the camera lens (inside the lid).Note!Position it the same way/direction as w
33IMG-242240 Cargo compartment, preparationsApplies to cars with two rows of seats● Fold up the floor hatch (1). If the floor hatch is equipped with a
36IMG-242242 Cargo compartment, preparations●Remove the panel.37R3903738● Pull off the rubber strip on the rear edge of the door opening for the left-
40R8504315Applies to cars with two rows of seats● Remove the screws (2) on the load securing eyelets.● Remove the cover (3), by prying off using a wea
44IMG-242245 Preparations, passenger compartment● Carefully prise loose and remove the panel over the joint between the door sills.45IMG-242246 Prepar
48IMG-242247 Preparations, passenger compartment● Fold down the backrest.●Remove the seat links and bolts.● Lift out the seat.Caution!Exercise care wh
52IMG-273225 Steps 51-66 apply to cars with an accessory electronic module (AEM) installed ● Remove the lower folding side panel on the right-hand sid
54IMG-274171 Steps 51-66 apply to cars with an accessory electronic module (AEM) installed ● Remove the cable ties from around the cable harness to th
Required toolsA0000162IMG-239660IMG-239942IMG-240693IMG-239981IMG-246925IMG-240675IMG-239664IMG-242205IMG-274123IMG-213320Installation instructions, a
58R3703512Steps 51-66 apply to cars with an accessory electronic module (AEM) installed ●Remove the red (R) cable from terminal 22.59M3904942Steps 51-
62R3603578Installing the cable harness● Take the new cable harness (purchased separately), marked A in the kit image and place it behind the battery.●
64R3603579● Take five cable ties from the kit and secure the wiring harness to the existing wiring harness as illustrated.● Remove the ground screw an
68R3603615Installation, parking assistance camera (PAC)● Take a Velcro fastener and cut it off 90 mm (3 1/2") from the edge.69A0000335Installatio
72R3603612Installation, parking assistance camera (PAC)● Take a Velcro fastener and cut it off 75 mm (3) from the edge.73R3603616Installation, parking
76IMG-242253 Installation, parking assistance camera (PAC)● Secure the control module on the newly attached Velcro fasteners. Press hard so that sits
80IMG-222283 Installation, parking assistance camera (PAC)● Press the Velcro pieces together.81IMG-222285 Installation, parking assistance camera (PAC
84IMG-242258 Installation, parking assistance camera (PAC)● Connect the three connectors to the control module.85IMG-242259 Installation, parking assi
88M3703366Connecting the rear electronic module (REM)● Carefully prise apart the sides of the connector holder in the ends so that the connector can p
92IMG-274235 ● Connect the large black female connector in the pre-routed cable harness to the fuse holder. ● Connect the towbar wiring connector, whi
Installation instructions, accessories - Park Assist, camera Volvo Car Corporation Göteborg, SwedenInstallation instructions, accessories - Park Assis
96IMG-242261 Connection to multimedia module (MMM)● Route both adapter cables (5 way green and 12 way gray connector) along the molding and up to the
100IMG-246927Installation, ground strip● Insert the tool's hook between the dashboard and the louvre. Turn the tool 90° and pull the louvre strai
104IMG-246933 Installation, ground strip●Take the earth braid and foam tape bit from the kit.● Cut off the foam tape lengthways in two equal pieces. C
108IMG-248723 Installation, ground stripSteps 108-113 apply to cars with a centrally mounted loudspeaker ● Remove the three screws for the monitor.● R
112IMG-248727Installation, ground strip● Reinstall the monitor and tighten using two screws as illustrated.113IMG-248728 Installation, ground strip● T
115IMG-242268Finishing work● Download the software for the accessory's function following the service information in VIDA.● Check the position of
INTRODUCTION● NOTE! Read through the entire text before carrying out any work.● The front page gives the date of this edition and the edition it repl
1IMG-242207Installing the camera●Remove the number plate and holder.2IMG-242208Installing the camera● Apply tape to the boot lid to protect the finish
5IMG-242211 Installing the camera●Use a short drill bit and drill holes according to the template.Note!Do not drill through the template.6IMG-242212 I
9IMG-242215 Installing the camera● Remove the border around the handle by pressing in the two catches with a screwdriver (1) and at the same time pry
13IMG-242220 Installing the camera● Mark out and drill with the holesaw as illustrated.● Vacuum.14IMG-242221 Installing the camera● Mark out and drill
17R8504201Installing the camera● Remove the rear roof panel covers and the screws beneath them.● Carefully pry off the panel at the rear edge. Use a p
Kommentare zu diesen Handbüchern