Volvo RTI Betriebsanleitung PDF herunterladen

(This will work both for the small and the wide Display)

Video can be seen on: http://www.nasab.com/Volvo/tip-trick.htm where we have put up some video

from our test and the last one which is a final working Standard Navigation in Volvo RTI unit.

(Final edition together with NAV Voice Guide over TV tuner)

First of all everything depends on how much you want to spend both in money and time (When we refer to

cost we do not consider NAV unit only the cost for some electronic parts, connectors and cables):

1. You can make the replacement very easy and cheap by just take out the RTI Display and replace

it mechanically with a TOMTOM, Garmin or Lark NAV which has 4.3 inch Display and use a

switch to operate the Up/Down and to turn the NAV On/Off. This is the simplest way of doing it.

2. You can use a sophisticated pc board with microprocessor to communicate with the can bus and

by then you would be able to operate the RTI Up/Down with the original keys on the steering

wheel or by the remote control. This is very complicated and difficult solutions and expensive and

you need to have know how, how to programming microprocessors and not very easy for the

common person to achieve. In this way you also have to mechanically replace the RTI display

with some kind of NAV.

Our Project

3. Our NAV have Dimensions: 295.6 x 204 x 7.95 millimeters and that is max what you can use in

Volvo with the small Display. (Measured outside the NAV). And remember feathers like back

camera, video etc. depends on what kind of NAV you buy.

This way you replace the RTI mechanically and use some of the feature which is original in

the RTI electronics. We will in detail show this method as we think it would be the most

suitable way of replace the Volvo RTI with some kind of NAV where almost everybody can

do it as long as they have some kind of mechanical and electronically knowledge and it do

not cost more than between 10 to 50 Euro in material. We choose this way where you do

not need any programming and still have some feathers which operate the RTI

Display/NAV Up/down starts the NAV automatically when the RTI goes “Up” and shuts

down the NAV when the RTI goes “Down”. You can also use the original bottoms on the

steering wheel or the remote control for sending the RTI Up/Down, but nothing else.

Replacement of RTI Display Unit to

NAV in Volvo (RTI CD Early models)

REV. 1.5(Another way of doing it, see the end of the document)

1 2 3 4 5 6 ... 23 24

Inhaltsverzeichnis

Seite 1 - Our Project

(This will work both for the small and the wide Display) Video can be seen on: http://www.nasab.com/Volvo/tip-trick.htm where we have put up some vid

Seite 2

In this test we have been using Lark Freebird 4.3 inch NAV (Problem only Polish maps), but you can use whatever NAV in the marked as long it will fit

Seite 3

Electronic Schema NAV/RTI for NAV without Push Bottom 5V DC Version (For NAV which starts automatically when power is connected) This will automatical

Seite 4

Electronic Schema NAV/RTI for NAV without Push Bottom 5V DC Version. (For NAV which starts automatically when power is connected) This will automatica

Seite 5

+12V to Special Electronic 0V to Special Electronic And to NAV charger. +12V for Charging NAV (+12V when ignition is on.

Seite 6

Sunday, March 16, 2014 Some result of test: For the past week we have been having this equipment installed in one of our Volvo V70 01 and the result h

Seite 7

Where you have replaced RTI Display with NAV in Volvo. (RTI CD Early model) (Second Edition) We will in this document show how you can use original V

Seite 8

Now we have the TV unit without AF. As you can see we had an extra PC Board on our unit, some are with and some are without. If you have with

Seite 9

Seite 10 - Electronic Schema NAV/RTI

Connector To reverse camera and video) To RTI Control module Connector To RTI control module To CD Changer, Yatour etc.

Seite 11 - 5V DC Version

Seite 12

We will start to show how you dissemble the RTI Display. 1. First take out the complete unit from the car. 2. Take away the plastic cover over the R

Seite 13

Seite 14 - Some result of test:

On the main board of the TV tuner there is an IC which is a Three Video Input, Three 2 channels Audio Input and Two Output circuits. The I

Seite 15 - External Sound for NAV using

right side from the power connector to connect your Video or Back Camera. Then you can use this IC to setup the switches. But as we said it will be in

Seite 16

Nasab International Corporation Special Machines/Electronic Department. How to use RTI Displa

Seite 17

We will be back when we has connected a back camera to the TV unit in the trunk of the Volvo. M3 screw with a M3 nut

Seite 18

Take 2 small cable peaces and connect one to the negative (outside) of the Nokia charger and the other one to the hole on the middle of Nokia charger.

Seite 19

Take away the 2 screws holding the plastic cover over the display and open separate the back side from the front side of the plastic cover. It

Seite 20

Now we have a clean pc board without any display. On the backside take 2 pcs. of rubber to make the distanse (the thickness depends on which

Seite 21 - Second Part

Put a small dubbelsided tape or some rubber with glue on one side in the left side of the plastic front. This we did because there is a level differe

Seite 22

As you can see we have taken away the plastic for the USB connector due to it is very tite and also connected a plug for external sound as whe

Seite 23 - Volvo (RTI CD Early models)

To get power +12V DC to the extra electronic we soldered 2 cables to the standard connector of the RTI. Pin 11/12 is +12V DC from battery and Pin 15/1

Seite 24

Before you close the cover of the back you have to connect the Nokia charger and let the motor take the RTI display with your NAV to down possition. A