Volvo D12 Spezifikationen PDF herunterladen (Seite 15)

Volvo Trucks North America, Inc. Date Group No. Page

TSI 8.2003 215 001 15(21)

Install the front cover positioning tool, J–41272. Tighten

bolts to align front cover. Torque the cover mounting

bolts to 33 ± 4 Nm (24 ± 3 ft-lb). Verify that the cover

is flush with the head.

Note: Tighten positioning tool, J-41272 until upper front

cover is flush with cylinder head on both sides.

J–41272

33 ± 4 Nm

(24 ± 3 ft-lb)

Remove tool, J–41272.

Note: Remove any sealant that gets on the cam sensor

wheel to prevent any sensor signal faults.

Rotate the camshaft until the cam sensor wheel tooth

aligns with the cam sensor. Verify that the air gap

is between 0.3 – 0.7 mm (0.012 – 0.028 in.). Adjust if

needed by removing or adding shims between the

sensor and the cover. Relocate the timing cover, before

the sealant hardens, if necessary to aid in obtaining

the proper air gap.

T2006672

Remove the engine turning tool and reinstall the cover.

9996956

Install the VEB solenoid harness and torque nuts to 1.4

Nm (1 ft-lb). Fasten all clips. Connect the external

harness to the front cover.

1.4 Nm

(1 ft-lb)

Clean the valve cover and gasket contact surface.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Keine Kommentare

Volvo D12 Spezifikationen Seite 15