Volvo D2 Series Betreibershandbuch PDF herunterladen (Seite 35)

Stopping the engine

The engine should be run for a few minutes at idle (in neutral) before turning it off. This will avoid boiling and

even out the temperature. This is especially important if the engine has been operated at high engine speeds

and loads.

Stopping

Press the Stop button (1) untill the engine stops run-

ning.

After stopping the engine

● Inspect the engine and engine compartment for

any leaks.

● Close the fuel cock and sea cock for the cooling

water intake.

IMPORTANT! Do not forget to open the cocks

before the engine is started again.

● Read off the hours counter and do preventive

maintenance as in the maintenance schedule.

● Switch off the main switch if the boat is not to be

used for some time.

IMPORTANT! Never break the circuit with the

main switches while the engine is running. This

could damage the generator.

Cold weather precautions

To prevent freezing damage, the seawater system

must be drained and the freshwater system coolant

must have sufﬁcient antifreeze protection. See chap-

ter Maintenance ”Cooling systems”.

IMPORTANT! A poorly charged battery may

burst as a result of freezing.

Laying up

If the boat is not going to be used for some time but

is being left in the water, the engine must be run to

operating temperature at least once every 14 days.

This prevents corrosion in the engine. If the boat

will not be used for more than two months then

inhibiting should be carried out: See chapter “Laying

up/Launching”.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

Keine Kommentare

Volvo D2 Series Betreibershandbuch Seite 35