Volvo TAD1345GE Betriebsanweisung PDF herunterladen (Seite 55)

Engine Oil, Change

WARNING!

Hot oil and hot surfaces can cause burns.

Oil changes must be done when the engine is warm.

1 Connect the drain hose to the oil drain pump and

check that no leakage can occur.

2 Pump the oil out (or remove the bottom drain plug

and drain the oil).

Collect all the old oil and old filters, and leave them

at a re-cycling station for destruction.

3 Remove the drain hose (or install the bottom drain

plug).

4 Fill with engine oil.

For change volume, please refer to Technical

Data page 67.

Oil Filter/By-pass Filter, Change

WARNING!

Hot oil and hot surfaces can cause burns.

1 Clean the oil filter bracket (2).

2 Remove all oil filters with a suitable oil filter extrac-

tor (1).

3 Clean the mating surface of the oil filter bracket.

Make sure that no remnants of old oil seal are left

behind. Carefully clean round the inside of the pro-

tective rim (2) on the oil filter bracket.

4 Put a thin layer of engine oil on the seal rings of the

new oil filters.

5 Install the new oil filters. Tighten the two full-flow

filters (on the right of the illustration) 1/2–3/4 of a

turn after they bottom. Tighten the bypass filter 3/4–

1 turn after it bottoms.

6 Top up with engine oil, start the engine and let it run

for 20-30 seconds.

7 Turn off the engine, check the oil level and top up

as required.

8 Check the sealing round the oil filters.

P0004307

Maintenance

7748641 06-2010 51

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 81 82

Keine Kommentare

Volvo TAD1345GE Betriebsanweisung Seite 55