Volvo TAD1345GE Betriebsanweisung PDF herunterladen (Seite 61)

Coolant, Draining

WARNING!

Do not open the coolant filler cap when the engine is

warm, except in emergencies, this could cause serious

personal injury. Steam or hot fluid could spray out.

IMPORTANT!

On engines which are to be laid up or put in storage,

the engine cooling system must not be drained. The

coolant contains corrosion-inhibiting additives.

1 Stop the engine.

2 Remove the filler cap (1). Do not open the pressure

cap (2).

3 Open all drain points. Drain the coolant from the

radiator and engine block, using the drain hose.

The drain nipples are situated under the radiator on

the right side of the engine block.

4 Check that all coolant drains out. Deposits may be

found inside the drain plug/tap, and need to be

cleared away. There is otherwise a risk that coolant

could remain and cause frost damage. Check

whether the installation has any further taps or

plugs at the lowest points of the cooling water pipes.

5 Shut any taps and check that the spring-loaded

covers on the nipples close completely. Install the

rubber plugs.

Charge Air Cooler, External

Cleaning

Remove guards as necessary, to access the cooler.

Clean with water and a mild detergent. Use a soft

brush. Be careful not to damage the radiator matrix.

Re-install the components.

IMPORTANT!

Do not use a high pressure power washer.

P0002095

Maintenance

7748641 06-2010 57

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 81 82

Keine Kommentare

Volvo TAD1345GE Betriebsanweisung Seite 61